Description

You are buying 300 X piece of 16.5 cm long x 1mm in diameter of QuickAlloy SMT1-L Desoldering Alloy bar Save Surface mount Rework Costs with

300 X   QuickAlloy SMT1-L Desoldering Alloy

    The concept is simple since normal lead based solder on the board have a melting temperature at 240 C Desoldering Alloy have a much lower melting temperature of ~50 C, therefore by mixing (dilute) the two alloys together you get a melting temperature some where in between and closer to 50 C. which allow you time to desolder complex surface mount component like FPC connector or socket connector off the board safely and effortlessly.   Regular lead based solder joint mixing with

QuickAlloy SMT1-L = easy and safe surface mount board repair.

    By reduce the rework soldering temperature This special alloy will significantly reduced you solder rework soldering temperature. Prevent heat related damaged to the copper pads on board. Protect potentially heat damage to neighboring components or small chips.

Instructions (with soldering iron or heat gun)

• Apply flux to all leads.
• Melt QuickAlloy SMT1-L uniformly on all pins (you need the temperature to be high enough to actually melt the original leads at least once in order to get the desired result as described).

• Maintain alloy in molten state long enough to release chip (or FPC connector).
• Lift chip from board with a pick or tweezers.
• You can use this to change iPod, iPhone, iPad, dock connector, FPC connector, coil, resistor, wifi holder, battery connector (this is what we use in our repairs)

CLEAN UP

• While molten, use Solder Wick and flux to move excess to an unused section of board (Usually the middle of where the component was).
• While applying heat, polish each pad with a swab and flux until thoroughly clean.
• At room temperature clean residue with alcohol.
• You are now ready to install the new chip.

This alloy is recyclable and reusable for many repairs, simply heat it up with the soldering iron and you can reuse the alloy lump in your next repair job.       This alloy does content 1/5 Lead, lead is air stable and safe in temperature below 1,750 C (Vaporization – Temperature of lead) aside from that you shouldn’t ingest lead of course that’s not safe. Cadmium FREE WARNING: This product contains lead,